crxmatt

Ok so I have a d16y7 in my wife's 99 and the transmission was making noise
When the clutch pedal was up so I replaced the input shaft bearing and it's still making the
Noise I checked the clearences and bearing play when I had it apart
And everything else was fine I'm clueless right now and a part of me wants to
Brake down and cry any suggestions ?

crxmatt

Has anyone ever had a problem with the output shaft bearing making a rolling whirrling type of noise.

sixcyl?

Sounds more like a throw-out bearing to me.

da4door

Sounds like throw out bearing

crxmatt

replaced the clutch, pressure plate, throwout bearing and pilot too

the throwout bearing typically would make noise when the clutch pedal is pushed in not when the pedal is up and the
clutch is disengaged

T-Hybrid#2

CRXMATT.. I thought a throw out bearing would make noise when the pedal is up then go away once the pedal was pressed down.. ?? Just wondering..?

power2weight

No throw out will make noise when the clutch is engaged. What kinda throw out did you install? If its eBay you need a new one. Bearings inside the trans make noise when you're in gear and driving, it'll be a whining noise. So if it makes noise in neutral with the clutch engaged its the throw out. Pilots rarely make noise but cause the clutch to be hard to push do to the input shaft not lining up with the center of the crank, if it does make noise it will be while the clutch is dis-engaged.

CoryKnowles123

Check the trans fluid?

PicovAndropov

How about the main shaft bearing?

crxmatt

I'm starting to suspect that as well just sucks having to take
Everything apart again