i have DSM 450cc injectors and will be installing hondata s200 with boost op on a 95 ls swap. do i need a resistor box to run the injectors or will the hondata be programed to run the 450's. i don't think i need a resistor box but i just wanted to make sure.

jay

 

to the best of my knowledge, you will need the resistor box or inline restistors for the dsm injectors. Due to the low impedence of the injectors.

 

I'm pretty sure you will need a resistor box. Also it's recommended that you use aftermarket injectors with Hondata.

 

Ya, those 450cc's might now do it. There are Starion injectors on Ebay, I think 850cc's or so. Check it out.

 

Are stock starion injector are 850cc? Mmmmm..might have to check on some

 

1600cc like me...you will never have a fuel problem

 

Ya, I think I might be running 2 secondaries in a few months. As of stock there is a primary and a secondary.

 

yes, you do need the resistor box.......

 

You do need it, but Shad will tell you that Hondata doesn't really like DSM injectors because it still doesn't match up like a high impedance would. late

 

well that sucks, cause i'm most likely goin to get shad to tune my car... don't want to give him any excuses for him to slack on my tuning....