ignition switch fuse red hot. smoking coil.
#1
Registered Member
Thread Starter
Join Date: Feb 2006
Location: Fredericksburg
Posts: 2,029
Likes: 0
Received 0 Likes
on
0 Posts
ignition switch fuse red hot. smoking coil.
ok so my 240 has been down so have been trying to get back to running these past 4 days. it had no spark, put in a msd blaster with ballast. then all sortsa shit went bad.
well today after getting everything ready i go to turn over. battery's dead. so hook up jumper cables and try and start 240. makes horrible starter noise (not grinding teeth but trying to turn over) then go check out fuses and ignition switch is blown. replace it with another and stars getting red hot (ignition to on). and over by my msd (looked like the resistor) started smoking....
any ideas?
well today after getting everything ready i go to turn over. battery's dead. so hook up jumper cables and try and start 240. makes horrible starter noise (not grinding teeth but trying to turn over) then go check out fuses and ignition switch is blown. replace it with another and stars getting red hot (ignition to on). and over by my msd (looked like the resistor) started smoking....
any ideas?
#2
MoltenMetalFuzion
Join Date: Sep 2005
Location: Roanoke
Posts: 1,258
Likes: 0
Received 0 Likes
on
0 Posts
Re: ignition switch fuse red hot. smoking coil.
Get rid of the MSD. I had the same issues with a car I owned a few years back. Solution- throw the msd bullshit in the trash.
If you decide against this, all I can say is good luck
Just my .02
#4
Turbo VTEC-E
Join Date: Oct 2004
Location: Memphis
Posts: 1,520
Likes: 0
Received 0 Likes
on
0 Posts
Re: ignition switch fuse red hot. smoking coil.
+1. If the fuse is getting hot like that there is something wrong. There is something that is drawing too many amps, and if this only started when u installed the MSD i would get rid of it or doublecheck the wireing.
#5
Registered Member
Thread Starter
Join Date: Feb 2006
Location: Fredericksburg
Posts: 2,029
Likes: 0
Received 0 Likes
on
0 Posts
Re: ignition switch fuse red hot. smoking coil.
well i wired in the msd with the resistor only because my stock resistor went bad. so maybe i wired the resistor for msd wrong but idk honestly
#6
Registered Member
Thread Starter
Join Date: Feb 2006
Location: Fredericksburg
Posts: 2,029
Likes: 0
Received 0 Likes
on
0 Posts
Re: ignition switch fuse red hot. smoking coil.
ok. my stock resistor had 4 wires (coil +, coil -, resistor - and ecu wire) so i cut the + and - for coil and wired it to the resistor. the stock resistor and ecu wire are still plugged in. and another ground is grounded on msd too.
quick ? the msd reistor isn't case grounded is it?
quick ? the msd reistor isn't case grounded is it?
Last edited by murphy660; 08-26-2007 at 07:24 PM.
Thread
Thread Starter
Forum
Replies
Last Post
sikcrx89
Parts ARCHIVE
10
02-17-2008 02:30 PM