Ight, let the problems begin...

I have a ODB2 Car and I have a 94 SIR2 B16A which should be ODB1. Now here is my problem, I have been trying to either get this check engine light to either RESET or FLASH the ECU code, and which both i have been unsuccesful. I would like to flash the code but i have tried EVERYWHERE with a paper clip and nothing. Any Suggestions?

This is my wiring setup (Pic)

 

that is an obd2 to obd1 conversion harness correct?........and im no help unless i saw it myself and could look around.........so the code isnt flashing at all, its just staying on the entire time?.......

 

its not even flashing, just shutting off..

 

you could have an igintion mix up somewhere or distibutor gone bad, i mean does it run for a few minutes and then shut off or does it just start up and then shut down automatically?.......

 

Where did you get the harness?

 

I'll just say autosolutions did my swap, nuff said..

 

How about some more info on what is happening, what is the engine doing?

 

absolutely nothing...just the CEL is on..has a small anti-freeze leak from the heater hoses, but that is something that is not sensored..

 

I'll email you the harness pinout..

 

Did you put the paper clip or wire prefered into the two wire plug to check the code.........looks like the green plug at the very top right hand of your pic, not entirely in the pic