ok i had a 94 integra(obd1) and i blew the motor so im having a 97 obd2 in. will this work without any problems or anything? or do i need to change somethings?

 

No problems. Yes your harness, distribitor, and intake manifold. Everything else is plug and play.

Also, you can keep the crank angle sensor down by the crank. No need to remove it, as it's not hurting or helping anything. It's just keeping the belt on the crank.

What did you do with your old motor?

 

iono i think the place doin it is keepin it. it needs a new block i blew a whole out the front and back of the block. and thanks.

 

If someone else is doing the work why do you wanna know?



And wtf did you do to that thing to blow it up like that.

 

i was goin a lil too fast with not enough oil.

 

Don't feel too bad man.

I lost my first motor due to that, but I rebuilt it myself.

Oil pressure gauge ftw.

 

i knew i was a bit low on oil but i had to make a decsion get fired from work or take a chance and make it there and buy oil at the gas station across the street when i got off but never made it there =[