PRO-Habit

I have a 96 sohc dx (d16y7). I bought the vtec head and manifold (d16y8) and p28 ecu to do a head swap. I was wondering if someone could give me a little help on how to install it right. Someone was telling me I have to drill new oil lines in my block or sumthin to perform this swap. Any info will be greatly appreciated.

mateo189

no u do not need to drill any oil lines. exchange heads and wire up vtec

sk8rmike

that P28 ECU will not work with your vehicle. you need a P2P which is an OBD2 ecu. your car is obd2 and therefore wired for obd2. the actual head swap is a direct swap.

PRO-Habit

Ok so I need a p2p ecu. Now wut is all this I've been hearing about a "oil control jet"? I read that I have to remove this from my engine, beacuse the vtec head supposedly already has one in it?? Any info??

sk8rmike

its this little thing that sits in the block. you can use a screw to pull it out once the head is off. very simple.

Spindrift

super glue and duct tape....

PRO-Habit

Or maybe sum pvc pipe??? (240sx) hahaha

Spindrift

PVC pipe is not to be fooled with by the unknowledgable...And that ghetto shit was there before I got it lol.

PRO-Habit

Ok but for real........ When I get around to hookin up the P2P, how do I wire in the vtec, or will it jus plug up?

PRO-Habit

really need help with the wiring