can anybody give me a bolt diagram or something to figure out where my engine bolts go like for my front cover and everything up there? somebody mixed all mine up and now i have to sort them out and would like an easier way to do it, thanks

 

if only the front bolts are mixed it shouldnt be hard at all to figure it out.

 

i dont think youre going to find a bolt diagram. the timing cover bolts are 10mm heads that are about inch long i guess. theres 4 10mm bolts that are about half an inch long that goes to the water pump pulley. theres 4 12mm bolts with the number "8" on the head that goes to the crank pulley. theres 3 12mm bolts that go to the a/c tensioner bracket. theres some long 14mm bolts that go to the motor mount and a 17mm nut that goes to the side of the motor mount. thers 2 14mm nuts that go to the other side of the motor mount. i hope that helped you out some. good luck

 

Take your pulleys off much?

 

man ive taken 4g63s apart so many times, i could probaly look at a bolt and tell you what hole it went in. lol

 

Go to the dealer and copy the service manual. Thats what I do.

 

ive got a diagram in my book but no way of puttin it to computer, but yeah its a pain in the ass figuring which bolt goes where, i ended leaving alot of mine out since the cover comes off so much

 

I can tell.. wanna come out to roanoke and help me put one back together?

 

the dealers manual tells you the length,... of each bolt in metric

 

for the timing cover bolts start with the short ones and work your way to the longer.

the upper cover has 2 bolts with a molded washer (best way i could think to describe) no loose washers
in general the short ones go around the outside
the one on the bottom back has a bigger washer than the rest (6 to 7 bolt this one is different)
i believe the longest one goes top back with the top cover on

thats all i can think of