ok so yea i installed it based on hondata's instuctions

anyways on there site it said b-series had a white wire. and the rsx had a i think red/yellow? wire

but mine is bseries and was the rsx color which at the time i didnt car cause the other 2 colors matched so the 3rd had to go in the 3rd hole.

but after installed it i had both map sensors hooked up. the car wouldnt idle.

i unhooked the oem one. the car still wouldnt idle.

i unhooked the gm 3bar and rehooked the oem up the car ran

then installed the gm again and the car ran fine with the oem one unhooked.

so i cut the car off then started it again and it wouldnt idle.

im currently on an ood1 p72

but my question is do i need to install my p72 with the s300 to get it to run correctly with the new sensor?

 

forget it i figured the problem out.

close thread