Boi Boi

if ur using a dsm injector on ur honda...i need ur help...i need to know what do i have to do to put them in there?...i mean the seal on the bottom of the injector...do i have to do mods to the seals or i can just put them in and not have to so anything to the rubber seals?....i need ur help cuz i want to get my car tuned asap

zappas

yea, they will fit as is, but your going to need a resistor box for them.

thermal

you may have to bore out the bottom injector seal. I had to on mine...... Yes, you have to use a resistor box or inline resistors

92EH3

^ what they said and you should replace all of the o rings too

thermal

Also, you have to have a way to control it. you cant just slap it on and call it a day. The biggest injectors Honda stock ECU's can idle is 370cc'c. Even that is a close call.....

zappas

yea, what are you tuning with? vafc has hacks for running dsm injectors..if your running that....

Boi Boi

amma get it tuned on crome...but i did a lot or research already mostly on honda-tech and the injectors can work on my car using the stock resistor box...i have a 90 da..

92EH3

are you gonna upgrade your fuel pump? you will need to run the 450s

Boi Boi

yeah i did most of the upgrade especially the pump (i have the walbro 255 high flow) except for the 450s that im trying to figure out what else do or modify to put those on...everything else is good...

Fabrik8

Yep. Honda went high-Z in 92, and then resistor boxes became unnecessary.