cold air intake question
#1
Registered Member
Thread Starter
Join Date: Jul 2006
Location: chesapeake
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
cold air intake question
sorry if this is in the wrong section... I was wondering if i snaked my intake piping out to the front bumper and had the filter sitting like in the front bumper area in front of the radiator.. as seen in the pic.. if it would run horribly in the rain or a light mist.. just a question to all you car gurus
like in the pic im talking about the space right below and behind the front tag
like in the pic im talking about the space right below and behind the front tag
#2
UNCE UNCE UNCE UNCE
Join Date: Jun 2004
Location: J'Ville FL.
Posts: 9,811
Likes: 0
Received 0 Likes
on
0 Posts
Re: cold air intake question
I know APC made an intake that mounted like a FMIC. IMO that would increase the chance of sucking up water and soaking the filter. I mean I imagine you can't really hydrolock your engine unless the filter is completely submerged under water, but I see more cons than pros in doing what you're trying to do.
#4
I have a 20 valve...
Join Date: Nov 2002
Location: Sunny San Diego, CA
Posts: 3,266
Likes: 0
Received 0 Likes
on
0 Posts
Re: cold air intake question
it wasn't apc, it was Aerospeed.
It would be a great idea, but again with the hydro locking issue. Put it all the way down to where your resonator is on the front tire ( I don't know nissans but honda's had them on the right side)
Plenty of protection and cold air there.
It would be a great idea, but again with the hydro locking issue. Put it all the way down to where your resonator is on the front tire ( I don't know nissans but honda's had them on the right side)
Plenty of protection and cold air there.
#5
Registered Member
Thread Starter
Join Date: Jul 2006
Location: chesapeake
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
Re: cold air intake question
ya mines on the right side like this
so itd just be taking the bend to the left out and doing down with it really .. so i actually with gain efficency
so itd just be taking the bend to the left out and doing down with it really .. so i actually with gain efficency
Thread
Thread Starter
Forum
Replies
Last Post
Prelude91siT
Want to Buy / Trade ARCHIVE
0
10-12-2008 08:09 AM