I need some help its a mini me swap a6 block/z6 head i have a obd0 to obd1 conversion harness. It runs fine but the only code that wont go away is 9 cylinder position sensor i replaced the dizzy with a brand new one and its still there? i can figure it out any help is appreciated.

 

check your wiring

 

ttt

 

What model car was the swap done to??

 

dx

 

Did you check your Dizzy wiring? And what dizzy are you using? You are using an OBD0 motor and an OBD1 ecu. Make sure the Cylinder postion sensors are in the same location on both OBD0 and OBD1.

 

i have a obd0 block with obd1 dizzy, head, and ecu