building jdm type r
 

i wanna build my jdm type r..but want a couple of opionins 1st....im thinking about getting some 81mm endyn rollerwave pistons 12:5:1 crower stage 2 cams and a port and polish job done on my head....i have this motor in a 96 gsr body and i want it to run mid 12's is this enough to do it?

Re: building jdm type r
 

No it will not be enough.

you need to bore that bitch out to like an 84mm

96 gsr with what? full internals? Gutted?

it depends on how light you can get that slut to be.

well 0psi since your a endyn dealer tell me what i need to do

Re: Re: building jdm type r
 

i will second that one becasue i know generally what 0psi has and i think he broke 12's will all more work done for all motor setup....

To run in the mid 12's in a 2600 lb car is very difficult. If you gut it out youll be in the low 2500's. You will have to make about 230-240whp to achieve your goal. Here is what it will take

81.5mm-87mm bore- you choose
12.5:1 and above compression
High Lift camshafts
built valve train
JDM ITR tranny is perfect
440cc Injectors Max
good tuning
good clutch

Re: building jdm type r
 

will it be enough, the hell are you thinking. i had A LOT more done to my B18C then what you are asking and i hit 13.8 in a 2gen teg. search around, 12's isn't easy. it will take more then bolt ons to reach it.

Re: Re: building jdm type r
 

agreed.....do some more research....

well im asking u guys what do i need to do..anf ive already been 13.8's with just a i/h/e cam gears