b182boost

i thought my clutch cable had broken,checked it out and all was good.i pulled the tranny and found the spring behind the throw out bearing was broke.The little peice that slips into the bearing itself broke,and the one on the outher side looked like it was about too.any way, replaced that,put it back together thinking it was all good.I push the clutch in(which feels fine),start the car, and when i try to put the car into gear it refuses to go.no grinding or anything like that, just wont go.cut the car off,release the clutch and it runs threw the gears fine.ANY IDEAS AT ALL ??? Also,when the car is running, i can hear a ticking when the clutch is engaged.It's a 92 hatch back with a zc swap, stage 2 clutch master clutch n a light flywheel. Thanks for all any intelligent ideas

b182boost

23 views,no ideas at all? i,ve racked my brain on this, any input at all right about now would be great. HELP!!!

Mindless

Put the spring in wrong?

b182boost

doubt it,it only fits one way

Mindless

Couldn't remember if it did or not.

b182boost

any way i fouled something up when iput it back in?

b182boost

when it broke, the clutch pedal got real tight and then it popped,but i need to figure out what would make it break,its my dd!!!!!!

B-Well

adjust your cable?
a better description of the new problem would help greatly

forced4gsix3

Check all the linkage on the pedal itself. I ran into this with a Tiburon. The TO bearing seized, pedal was hard. I kicked the clutch pedal and the TO bearing released but I also broke some shit on the clutch pedal. If you allready fixed the bearing and it's in there ok then it might be something in the pedal not letting the Master do it's job.

A lot of the stuff on the Tibby was plastic, I'm not sure about a Honda. That is where I would check next.