b20 swap
#1
Registered member
Thread Starter
Join Date: Jul 2007
Location: va beach
Posts: 513
Likes: 0
Received 0 Likes
on
0 Posts
b20 swap
i plan on going b20 in my ek but i have a few questions
1. do i have to use a ls intake manifold
2. what mounts would i need to use
3. what ecu would be best
any helpful tips about this swap would help out alot, i did research but didnt find what i was lookin for
1. do i have to use a ls intake manifold
2. what mounts would i need to use
3. what ecu would be best
any helpful tips about this swap would help out alot, i did research but didnt find what i was lookin for
#4
OV-104
Join Date: Jul 2006
Location: W. Palm Beach
Posts: 6,157
Likes: 0
Received 0 Likes
on
0 Posts
#5
braap braap
Join Date: Jul 2003
Location: Portsmouth
Posts: 14,535
Likes: 0
Received 0 Likes
on
0 Posts
#9
Re: b20 swap
are you going hydraulic tranny or cable? i dont think you have to worry about this because an EK engine bay is bigger than an EF but i had to use a b16 crank pully to fit it. what obd are you going obd2 obd1 obd0 ? ecu depends on what OBD ...
#10
JAY SPEC
Join Date: Sep 2003
Location: Chesapeake/ODU
Posts: 3,170
Likes: 0
Received 0 Likes
on
0 Posts
Re: b20 swap
anyways.
Some B20's come with an LS style manifold that works just fine, others have a very tall plenum that you cannot use because they hit your hood.
A Stock LS ecu should work fine. You can use the factory harness and add an obd2-1 conversion harness if you want to tune on a obd1 setup.