From what I have found so far I need all the 99-00 SI engine mounts, axles, and either an integra or a SI shift linkage. What else am I missing besides the engine, trans, ecu and wiring harness? I've read lots of conflicting info on what mounts work and what mounts don't. If there is a link out there somewhere that walks you through the entire B series into a EK process point me in that direction and I'll leave you all alone.

Thanks...

 

Another thing is I have that stupid exhaust manifold with the cat right in front of the motor. Do I need to buy stock cat for a Integra or SI? After that what catback do I need to get a hold of?

 

check out hondaswap.com look under the swap 101 article.

 

You need the si rear tranny mount, timing belt mount, and top tranny mount.

 

Thanks guys...

 

You do not necessarily need the Si harness. You can easily modify what you already have. I cant remember exactly.... but I think the IAT wiring must be modified. Your exhaust will have to be modified.

 

I saw that in another thread. I got a LS harness really cheap so I'm not really worried about it. I've found pretty much everything I need just need to figure out the AC bracket. I am buying a condenser, compressor and hard lines from a guy that came from a 99 si so I don't think the CRV ac bracket people usually use in these swaps will work since it's for a sohc compressor. I think I need the Si bracket now. Trying to verify that...

 

Figured it out... I need the SI bracket.

 

You cannot use a integra wiring harness in your year car. The way they are ran are totally different. Use your harness and modify if to suit.

 

Oh really? Definitely didn't know that. I need to find someone to modify the harness then because I really suck at electrical stuff.