b18a into 88 crx dx
11-25-2004, 09:01 AM
#1
BACK IN A G8
Thread Starter
Join Date: Jun 2004
Location: LEGION OF DOOM
Posts: 4,028
Likes: 0
Received 0 Likes
on
0 Posts
b18a into 88 crx dx
i need to know what needs to be done. it came out of zc4me's old car im taking the motor out and putting it in a 88 dx, since this motor has been rewired before what will i have to do. stock dx chassis harness is still in the car.
11-26-2004, 07:14 AM
#3
Speak&Spell Anyone?
Join Date: Jan 2003
Location: York County
Posts: 2,586
Likes: 0
Received 0 Likes
on
0 Posts
Re: b18a into 88 crx dx
you would have to convert it over to tune port injection... normally a shop would be able to do it. tuners edge does it.. im sure anyshop knows how to do it
11-30-2004, 11:38 AM
#7
BACK IN A G8
Thread Starter
Join Date: Jun 2004
Location: LEGION OF DOOM
Posts: 4,028
Likes: 0
Received 0 Likes
on
0 Posts
Re: b18a into 88 crx dx
wires have been switched but am not sure why the car won't start up, it just cranks could my timing be off that bad. and would spark plug wires in the wrong slots be it because i will double check them?
Last edited by 2ltrgsr; 11-30-2004 at 03:57 PM.
11-30-2004, 04:22 PM
#9
Boosted F2B
Join Date: Mar 2004
Location: coming back to VA..
Posts: 498
Likes: 0
Received 0 Likes
on
0 Posts
Re: b18a into 88 crx dx
if you already did the dual pt to multi-pt injector conversion then it should just be the timing or spark plug wires. if not then you may have not have the wires in the correct slots of the connector to the ecu, depending on if you are using a si or teg ecu. that is saying that your motor is obd0. if it is an obd1 motor then you will need more stuff: obd1 wire conversion or all the obd0 stuff (injectors/ecu/dizzy/o2 sensor)