Integra2Be

car: 93 integra with b18b1

is there some type of trick or anything i must do to the passenger side axel to remove it? driver side took 5 mins to remove. i have the passenger side all apart but i cant get it to seperate from the motor.

also, how can i get the shift linkage pin out?
i tried the clamp trick and tried using a punch. i dont know what to do now.

Thanks for any info! need to get this motor out today!!!

SCREECHO

Pb blaster for the linkage pin. Or a little heat or both.

Integra2Be

isnt pb blaster flamable? haha

00_VIP_BENZ

take a prybar and wedge it in between the axle and tranny just make sure you dont hit the seal. Spin the axle while prying it slowly.

Integra2Be

thats what i have been doing, i just cant get it to pop out

00_VIP_BENZ

it works just tap it with a hammer just to try and loosen it up. also with the shift linkage you need to make sure your using the right size roll pin punch. If not your just going to mushroon the tip ot the roll pin and make it that much harder to take out.

Mindless

Yup.