phathick

I have changed the entire brake system and hubs on my 91 SI hatch to DA stuff with Steel Braided lines. Come to find out the I think the booster isnt any good. The pedal goes to the floor. Anyway I bought a New Booster and master cylinder. I have looked every were on how to make sure the push rod is in the correct spot and cant find shit. Can anyone please help me out? I Want this shit to work out.

kanadaa

get the da brake booster?

WqYn3

i 4get how much it is but it has to be on point when you adjust those things.. ill check my books and find out for you.

CHAHONDA

when the booster goes bad the brake pedal will be very hard to push. when the master cylinder goes bad the brake pedal goes to the floor. you either have a bad master cylinder or a ton of air in the system

phathick

Yeah everything is DA. I have heard that the pedal would be hard if the booster was bad but I have a CRX that had a bad booster and a changed everyting but that nd it did the same thing. even if its not the booster Im doen both new anyways just cause everything else is new.

DORKO

stupid question, but did you bleed the brakes?

phathick

More times than you could ever think of!

DORKO

do you have a leak anywhere?

maybe you installed the master cylinder wrong, or the o-ring is squished letting air in the system.

phathick

Never took the two apart, They come off a DA and sat in the garage for a bit then onthe EF. Now NO Pedal. There is no leaks either. all the valves are closed and the lines are sealed. Not so much worried bout the old shit. Got new stuff just need to make sure its adjusted correctly.