norfolksfinest

i just bought a 91 civic hatchback last week with a blown head, and now im trying to convert the head to a d16z6. Not sure on wiring harness and specs, can anybody help me out , or does anyone know anybody that could help me put it in for a good price? thanks

Chubbs

i can install that for you in my shop

crxmadness

this might help

http://crx.honda-perf.org/articles/z6swap/z6swap.html
http://crx.honda-perf.org/articles/m...oreminime.html
http://www.honda-tech.com/zerothread?id=335078

norfolksfinest

how much chubbs, have you ever doen it before by any chance? let me know

SlowLS

you will have to do the MPFI conversion then buy an ecu from fabrik8 and run the 1 wire to the soliniod. Thats the easiest way to do it.

Chubbs

youll either need to convert to obd1 cause theres no obd0 vtec ecu, or you would have to use a vtec controller. call our shop at 721-9009 and ask for rich, he'll be able to give you more detail about it since hes done it on his crix

SlowLS

Fabrik8 makes an obd0 vtec ecu, so you will not have to convert anything. Also sets vtec engagement, rev limit, and puts a launch control on it for you.

Fabrik8

You seem to be forgetting about the OBD0 PR3 and PW0, either of which will need to be chipped to disable the knock sensor and remap for the correct engine. But yes, I also convert PM6s to have Z6 maps and a vtec output.

norfolksfinest

i have a pm6 and how much would you charge me for the ecu? would i be able to use my stock wiring harness with out the conversion? thanks, let me know asap

norfolksfinest

do you have a car with this conversion so i can take a look at it and see if that's what i want to do? nad where are oyu located, thanks