just curious, anyone know why when i hooked up a different radio in my car and used the proper harness connector, the radio works on Ign I (acc), but doesnt have power on Ign II (run) ? theres alot of electrical tape there already from someone on the stock harness wires, is it possible one is crossed? anyone else had this problem? im going out a little later to mess with it, but just trying to save some time if anyone else ran into this before.

 

nevermind... for some reason fuse 16 in the fuse block is not supposed to have anything in it, but i ran a voltage check, its closed at ign 1, and has a stead 13.28 with ign. 2, so i just ran a spade terminal from that to the main on the radio... works like a champ now.