89 CRX Si with 90 chipped PM6 rev limit
#2
Re: 89 CRX Si with 90 chipped PM6 rev limit
I had a PM6 in a Crx with a Ls motor and if i cut the car off and cut it back on real quick for some reason the rev limiter went away. I thought it was kinda weird.
#3
Re: 89 CRX Si with 90 chipped PM6 rev limit
Originally Posted by non-vtecpower
I had a PM6 in a Crx with a Ls motor and if i cut the car off and cut it back on real quick for some reason the rev limiter went away. I thought it was kinda weird.
#7
registeredbeerdrinkr
Join Date: Nov 2002
Location: Beaufort, SC
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
Re: 89 CRX Si with 90 chipped PM6 rev limit
yeah if the motor does not reach 180 the ecu will lower the revlimiter
did it to me when I had a low thermostat in the car.
did it to me when I had a low thermostat in the car.
#8
Banned
Join Date: Oct 2005
Location: Virginia Beach, Virginia fucka
Posts: 3,258
Likes: 0
Received 0 Likes
on
0 Posts
Re: 89 CRX Si with 90 chipped PM6 rev limit
Originally Posted by driveahonda
Has anyone had a problem with there pm6 not reving past 6500 rpm?
I am out of ideas, and cannot find the problem. Any clue?
I am out of ideas, and cannot find the problem. Any clue?
I had the same problem..and just put a PR4 ecu in it....let me go to 7000
#10
Banned
Join Date: Oct 2005
Location: Virginia Beach, Virginia fucka
Posts: 3,258
Likes: 0
Received 0 Likes
on
0 Posts
Re: 89 CRX Si with 90 chipped PM6 rev limit
yeah...i couldnt find a pr3 ecu..or a chipped ecu to run one wire vtec for my Y8 sohc vtec swap..so i just used a Pr4 till i could find one..and then i sold the crx.
it ran normal...but it will idle a lil bit higher
it ran normal...but it will idle a lil bit higher