*Need help w/ VAFC 1 wiring insallation for a y8 mini-me!*
#1
Registered Member
Thread Starter
Join Date: Sep 2006
Location: Va Beach
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
*Need help w/ VAFC 1 wiring insallation for a y8 mini-me!*
ok I have a y8 vtec head and I plan on doing a mini-me swap with my stock 91 crx si and need to know if everything I got for it will work out right and how to install a VAFC ver. 1. I got all new gaskets, new water pump, new y8 distributor, timing belt (either y8 or z6 dont know), and a VAFC ver. 1. If there's anyone out there that has a wiring diagram or any installion ish for the VAFC and/or knows about installing a y8 head in a stock 91 crx si I would really appreciate if you could help me out. I've looked everywhere online and can't find anything. If there's anything im missing as far as the parts go let me know plz cuz I want this to work out right and have nothing screwed up. Thx!
-Fabian
-Fabian
#2
TurboPipingSystems
Join Date: Jul 2003
Location: USDM Land, Va Bch
Posts: 1,483
Likes: 0
Received 0 Likes
on
0 Posts
Re: *Need help w/ VAFC 1 wiring insallation for a y8 mini-me!*
DL the manual from the Apexi website. If not, just get yourself familiar with the ECU pins on your car. After that, just tap the AFC wires by nomenclature.....
#5
Re: *Need help w/ VAFC 1 wiring insallation for a y8 mini-me!*
cant use the y8 dizzy cause it doesnt have crankshaft positioning sensor you gotta use your stock dizzy.....find the vtec pin out for a pr3 ecu and go from there
#7
Registered Member
Thread Starter
Join Date: Sep 2006
Location: Va Beach
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Re: *Need help w/ VAFC 1 wiring insallation for a y8 mini-me!*
all good, thx for the info though. A buddy of mine said I would have to wire the y8 diz to it cuz there diff plugs. Really I have no idea but I hope i didnt waste money on this dizzy >
#9
#10
Re: *Need help w/ VAFC 1 wiring insallation for a y8 mini-me!*
use everything on your motor now,you have to use your dizzy or get ready for a hell of a lot of wiring
heres what to do
take the vtec solenoid wire and extend it and run that to the ecu pin a4
screw a vafc its a waste unless your tuned imo
then for the oil pressure switch run the blue wire to pin d6 and ground the black wire
heres what to do
take the vtec solenoid wire and extend it and run that to the ecu pin a4
screw a vafc its a waste unless your tuned imo
then for the oil pressure switch run the blue wire to pin d6 and ground the black wire