I am looking to turn my blown 86mm GSR block into a coffee table. I've seen it done with V-8's but not many Bseries. I want to use head studs to secure the table top (not sure if I am using glass or plexiglass). But I'm not sure if I want to the internals seeing as some of them are were damaged i.e the pistons 3 and 4 are scrathed up, should I still use them? Also should I use other things like the water pump? Any input would be great.

 

I'd strip it down to almost nothing, and maybe leave the pistons in if you want. Depends on the look you're going for. Most of the V8/V10/V12 ones I've seen are just a bare block that's been cleaned up and either media blasted or painted/powdercoated.

 

I wouldn't do that. It won't hold up without sleeving it first.

 

the only problem is that the block isnt tall enough. ive thought the same thing. too short

 

Loll

 

weld the rods, with the pistons attached, to the sleeves (so theyre sticking way out of the cylinders) and sit the table on top of the pistons. But stagger the angle of the four rod/piston combo

 

Buy a k series block that's working, strip it and use that as a table. Profit.

 

Number one way to repel women from your house? Install a Honda engine coffee table.

 

Yeah not concerned with that. It's going to be game room coffee table

 

Ahaha.