Name: Corey
Contact: this thread or PM
Location: Newport News, VA
Price: OBO - see below

Most of these items will fit a 2002-2007 WRX or STi. They came off my STi and have literally ONE minute of run-time on them. The car had an engine installed in it when the new parts were installed and the engine ended up being bad (spun rod bearing). I purchased all of these parts new. I'd rather not ship these items. If I do ship, purchaser will pay shipping. I also accept PayPal, but the purchaser will pay the fees.

Items:

• Fujitsubo Legalis R exhaust - $500
• Turbo XS up-pipe (with flex joint) - $125
  
• XS power FMIC with HKS SSQV Bov flange (and Limited Edition black SSQV BOV) - SOLD
  
• Gruppe S equal length header - SOLD
• Invida downpipe with divorced bell mouth (Has dent on underside from car being slammed. This is the only part that isn't one minute old.) - $175
• Turbo XS Utec - $200
• ACT street clutch kit w/full face sprung disk - $500
• ACT Streetlight flywheel (15 lbs) - $250
• APS 70mm Cold Air Intake - $200
• Gimmick Motorsports silicone turbo inlet (red) - $120
  
• Race Comp Engineering Sway bars (Front and Rear - these bars are bright green as I was the demo car for Race Comp Engineering) - SOLD
• Kart Boy end links (front and rear) - SOLD
• Factory STi Diffuser with Cusco mounting bar - SOLD

 

Bump.

 

Bump.

 

i would love to get some pictures of the intake trough a pm

 

I would imagine those endlinks are for an STi and not a wrx?

 

It's a brand new APS 70mm cai. It's never been used. Ever. This is exactly what it looks like:


Correct.

 

i got an 06 wrx will the fronts work at all? i think they will. my car came with aluminum lca's

 

Are you talking about the end links and sway bar?

 

just endlinks

 

Hmm. I'm not sure. I looked on KB's webpage and it's hard to tell because they show two types of end links. The part number and pictures are correct, but again, I don't know for sure.