Ok heres the basics:

EG SI HB(sohc vtec)
USDM B18C1 Obd2 P72 ECU


I need to know everything i need in order to have this running into my friends Eg

We have:
FULL TEGGY SWAP(engine,trans,ecu,harness,linkage,axles,half shaft,etc.)

We are not gonna change out the harness(using si) so i am purchasing him a obd2 to obd1 jumper harness to run the p72 ecu

I just need to know what other things we have to buy to get it in the car...

if anyone can provide a nice write up it will be great(links also)

been searching on the web and nothing is giving me all the answers i need

EDIT:

Also the jumper harness im buying is gonna be from boomslang
its a p72 usdm ecu

do i buy the obd2A or the obd2B jumper harness

 

i can find every detail to that swap in less than ten minutes.

honda-tech.com , the button in the corner says "search". learn to use it.

 

im not signed up to honda tech =[

if u can find it in 10 min can ya help out?
post links and such

 

eh i found it somewhat but i need a better write up
something without too much of this info =[

 

You don't need the jumper harness. You will need an obd1 distributor, alternator and ecu. If you plan to use a DOHC ecu, you will need to wire for the knock sensor as well. If you plan to use a P72 ecu, you will need to also wire for the secondary intake runner butterfly. That is basically all you need. Trying to put that motor in his car and have it run in obd2 form is not what you want to do.

 

x1 plus is better if use the same harness from the si .all u have to do is get a obd 1 ecu and run the knock sensor wire