.

 

just use two..42mms..close enough...just spray some adhesive between the two.














j/k

 

Fixed, so he doesn't actually try this and blows his head and gasket...lulz

 

hey...if he couldnt see the j/k in white it wasnt my fault...

 

If you don't have a real answer then please don't post.he didn't ask for a smart ass so please if you don't k ow then move on
Thank you.
Try looking on toda I think they might have some close the that

 

SHUT THE FUCK UP!!!!

NO ONE GIVES A FUCK ABOUT YOU OR ANYTHING YOU HAVE TO SAY...

A CIVIC WIDEBODY...PLEASE POST A PIC OF THIS FINE JEWEL...

 

First things first;

0.085mm? Thats about 0.003" of an inch, or almost 1/4th the thickness of a piece of notebook paper. I'll assume you're retarded and meant 0.85mm which equates to about 0.033" of an inch. I'd bet your 'boy' could get a .030" head gasket no problem. In fact, through the mysterious powers of google, within 2 searches, I found a .030" headgasket; In fact, here you go; http://lmgtfy.com/?q=honda+head+gasket+ls%2Fvt Its the very first link.

Your friend is dumb for calculating this AFTER the purchase of other parts/during the build
Second ,

If he's shooting for at least 12.16:1 CR, then a thinner head gasket will just give him a higher number. If he wants that CR at highest, then simply get a thicker headgasket.