i need an aftermarket or whatever kind of mount that is goina keep my engine from smacking the crossmember anyone got anything?

 

I have the rear DA T bracket... Let me know if you want it... Call or PM..
Alan
757-319-3095

 

i have a b series rear mount and tranny mount i willl sell for a 20. the mount you are talking about is the one that bolts to the cross member. the t bracket is the same on the b series

 

so huh? i dont understand are you telling me there is supposed to be a braket in the front of the motor that bolts to the crossmember? because i thought that you cant use a front mount with a B series swap into a EF?

 

well i think he is talking about the rear. there is no front mount. if you have a stock mount on the rear it prolly dont line up good so you are prolly putting to much stress on it and if its stock then its prolly junk. the tee bracket on the rear are all the same as far as b series engines. if your mount is worn out then it will twist the engine to the front and the rear. but if you put a solid one on the rear then its not going to twist at all. then rear mount hooks to the cross member. the front cross member isnt really a supporting member. its there just to hold the radiator. and your torque bars but that is something else.

 

T brackets are different from 90-93 DA and 94-01 DC2 integras... If you buy the Innovative front crossmember, you can use a front mount... But either way, If you are talking about the rear T bracket, I have one..
Alan

 

i think he is talking about the brace that you can bolt on the front. if you look into the swap kits for h22 in crx or ef there is a bar that hooks to your frame and then you run to jon brace (they are adjustable). i think they are called jon braces. but anyway it mounts to the front and have two adjusters on so the motor is solid. but if your rear mount is not solid then you will have to replace it.

 

DONE CLOSE THREAD PLEASE