its a dx.

 

Read previous post on how to test.
All wires are at the ignition:
12volts - white
starter - black/white
ignition - black/yellow
accessory - yellow
second accessory - white/black

I did not mention specifically that you do not need to power the accessory wires in order for the car to start. Just jump the wire from the 12v to starter. It should crank. If it does, hold the wire to both starter and ignition at the same time. If the vehicle starts, remove the 12v from the starter WHILE holding it to ignition. As long as you keep the 12v to ignition after this point the vehicle will run (that is, if it starts at all).
Hope this helps.

 

was there ever an alarm on the car? possible starter kill

 

+1

Very good point

Figured he would've checked that by now though... LOL

 

make sure the switch at the end of the ignition is not loose

 

no never an alarm. its a dx. no power anything lol.

 

Follow the steps that I have listed.