p2r

Location: Central Va
Contact: Via PM or 434.989.8980 cell
Package Price: $1450.00


PLEASE KEEP YOUR BULLSHIT COMMENTS TO YOURSELF !!!



JDM B18C Sleeved Bare Block- $600.00 obo
The block has been equipped with Golden Eagle open-deck sleeves and blockgaurd. The motor was run for a few miles before the sleeves sunk. I talked to my machiniest and he told me that he could have it ready to install again for $250-300.00
Current bore is at 83mm, and there is plenty of room to work.
Block comes bare. Included are the mains, bolts, girdle, and thats about it.


B18B/B20 Knife-Edged Micro Polished Crankshaft- $500.00 obo
This crank was pulled out of a low mileage B18B and sent to my Machine Shop for work. It was used for under 1800 miles in my B18C bottomend. (LS/Vtec power with TypeR reliability) Not only do you gain power from the stroke, and the weight savings off your rotating assembly, but Nobody has to know... (The knife-edging is needed to clear the b18c oil squirters)


3 CARRILLO Rods for B18B/B20- $350.00 obo
These rods sell for $800.00 a set brand new, and are rated for 200hp/cylinder. They were used for 1800 miles and removed. I dont know where one of the rods went, but you can but a new one (weight matched) for $200.00 to complete the set. (Full set for $550.00)


10.2:1 CR Arias pistons (84mm)- $250.00 obo
Lightly used, and missing rings. Keep in mind, if used with the LS crank and rods, your compression will be higher (depending on your cylinder head).
Good for Nitrous or Turbo Applications!


I'll take pictures shortly. Looking for the imfamous tiny digital camera.

p2r

.

p2r

interest in the block

lmk ppl

p2r

.

p2r

.

p2r

.

p2r

.

p2r

.

p2r

.

p2r

.