close thread found a good guy who will help.

 

is the motor out?

 

dude ... why would i take the motor out...? im just taking the bolt out of the back T bracket, and then straping a come along around the bottom of the motor and the top strut bar then taking the bolt out of the mount on the tranny side. then while it's up on jack stands take out the axles and the cross member then let it down, the tranny side will drop unbolt the tranny after everything is unhooked shift linkage headers from the cat and starter is unhooked take off tranny. then unbolt the clutch then unbolt flywheel .then replace bearing in middle of flywheel then replace the flywheel then put the disk and presure plate on alignment tool place on the block. move bolt holes into position bolt it up jack the tranny back up into place and bolt it up. jack the whole thing back into place and put the mount bolts back in adjust the clutch and tada. no need to drop the whole motor, this is the way i saw my friend do it twice.