jdmtcan

NEEDS TO GO REMEMBER PRICE IS OBO!!!!

Tracy/jdmtcan
Hampton
757-660-9217or pm works too
$3600 or tade for a running 87-90 325is but would prefer cash

Blown motor at 120k miles was replaced by a high compression jdm d15b motor dyno# with apx computer chip 168hp 132ftlb
A/C and Power Str delete, ACT streetlight flywheel (11.7lbs), butter tranny no grinds-slips-jerks, F1 Racing clutch (stage 3.5 good for 250hp), partial wire tuck with resivoir tuck

Custom short ram intake, custom shaved and blue pearl painted valve cover(also comes with fully polished valve cover)

Full apexi n1 exhaust fabricated and installed by Shawn at Midas Hampton

Blox anodized blue lower control arms, cusco front strut bar, cusco rear strut bar, custom lower tie bar, all bushings and seals replaced

Time attack setup coils by Eibach (Eibach ProII)

interior upgrades: skunk2 short shifter w/type r shift knob, pioneer deck replaced all factory speakers with sony explods, 10" bass masters subwoofer with a mdx pro 500watt amp

REAL jdm vision industries corners (amber)
(the bad)
its on steelies or kosei k1's for 300 extra
the drivers fender has a few dents u will need anther one
(59.99 EBAY)
could use a paint job quoted at macco for 375.99

COME PICK THIS UP I REALLY NEED THIS GONE!!!

jdmtcan

bump 75 views