Pics of Targa seat cowl for the F4
These are for kwth8n. I just got back from Iowa a few hours ago. Hard to get pics while the bike's on my back patio.................
I didn't like it at first, but I hate the way the bike looks without it now. I'll be replacing the screws with some 1/4 turn fasteners.
I didn't like it at first, but I hate the way the bike looks without it now. I'll be replacing the screws with some 1/4 turn fasteners.
Last edited by CBR600F4; Sep 12, 2010 at 08:53 PM.
If you look at a stock F4 seat there is a strap that runs across it kind of seperating the rider and passenger portions of the seat. There are two clips that you slip over this strap and then put the cowl over those clips and screw the screws into them through the cowl. That's how it stays in place.
If it wasn't 3am I'd go take it off and take pics of it....................
Here's an old pic of my bike; you can see the strap in it: http://www.dragva.com/forums/showthread.php?t=48630
If it wasn't 3am I'd go take it off and take pics of it....................
Here's an old pic of my bike; you can see the strap in it: http://www.dragva.com/forums/showthread.php?t=48630
Thread
Thread Starter
Forum
Replies
Last Post








