I bought an 01 600F4i earlier this year and the guy that had it before put a fender eliminator kit. It still uses the stock turn signals though. The problem is, the turn signal stays on all the time. It still works as a turn signal though, but when it's not in use, it's just on and bright as hell! Is it rigged somehow? I checked the connectors, and it seems to me that it wasn't messed with(cut wires etc.) Anyone know how I can fix this? Turn the signal lights off when not in use?

 

lol, ok nevermind... the flush mount LED's that the former owner installed were wired wrong or something. I disconected the flush mounts to test them and BAM! Now I gotta figure out how to wire them right O_o so it'll all work together right.

 

they should be on until the turn signal is activated to cause it to flash
i would not disconnect anything

it is better to be seen than not

 

Well I was trying to install an integrated led tail light and that running light was causing it to not work properly. It would cause the turn signal part on the integrated tail light to stay on and the brake light part to not work at all. So, I just disconnected the running light wire and it fixed the problem. Now, I have a much cleaner look on the tail part. It used to have those huge turn signals on the back attached to my fender eliminator. I took those off and replaced the brake light with the integrated LED ones. Everything works fine now. The only thing is, the flush mounts doesn't stay on like it used to. But, it works fine when flashing. Now I should put some neons on the side to be seen better

 

neons no
LEDs yes
post pics

 

lol, i was jk bout the neons... I'll post some before and after pics later... my gf has my camera so I have to borrow someone else's

 

make sure to post them pics of your bike in the proper thread too..... please....

 

hmm, which thread? the "Post Pic(s) of a sick bike!!" thread?

ok, will do

 

before



after



sorry for the bad pics...took some quick ones at night just for show purposes

 

looks good