What's the difference between the ninjacustoms.net fender eliminator and the stock one, apart from signals?

 

Scrooz, you think you can set me up with a 16 tooth front and a 44 rear and a small hole in the airbox?

 

About $30 plus shipping...

 

sure thing. do you have specs on the airbox hole? i know thats been done a million times over, just wanted to know what sized hole people have found to work best. too big a hole can kill your low end power.

 

I say leave the bike alone and don't worry about keeping up with your buddies.. Enjoy the bike until you're ready for something bigger. Get a used 636 when you're ready to step up to a bigger bike, and it will respond better to mods, and make more power from the start as well....

 

simple thing NOS only 250$ for motorcycles

 

1" has been tested and proven on the ex500riders forums..too bad the site is dead.. ;(

 

I'm going to get the sprocket and the ninja customs fender eliminator. I'm waiting a little bit before the hole in the air box. So, basically this is what I need scrooz:

I'll order all the parts and can you install the fender eliminator kit, and the new sprockets? It might be a while, before I do the new sprockets atleast, but the fender emilinator should be pretty soon. I'll just call when everything is in.

 

Don't forget you'll probably need a new chain if you do new sprockets....

 

no prob, just let me know when you have parts in hand, and i'll get it taken care of for you.