newbie
06-25-2003, 04:53 PM
#1
Registered User
Thread Starter
Join Date: Jun 2003
Location: blacksburg/VA tech
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
newbie
hey guys I'm new to the site. I have been in the western va forum because i have been at VA Tech but i'll be coming home this weekend. I just wanted to say whats up to the richmond people. Also if there are any experienced honda guys I may need some help. I'll be putting my turbo in my crx next week.
Have fun...this group is a blast
...ehem.
06-25-2003, 05:56 PM
#6
ooooweee
Join Date: Apr 2003
Location: SOVA 804
Posts: 328
Likes: 0
Received 0 Likes
on
0 Posts
about time someone with a different car besides a mustang or probe or whateva on this forum...haha...=x welcome to the forums...im sarun...the one a lot of these people hate cause i wont go kick it hhaha
06-25-2003, 06:25 PM
#10
Registered User
Thread Starter
Join Date: Jun 2003
Location: blacksburg/VA tech
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
I have a 89 crx with the zc engine 1.6L DOHC, if your not familiar with the hondas. The botom end is simi built with pistons/rods. I will be using the 2 gen eclipse turbo (garrett t25) with a front mount intercooler and a zdyne stand alone engine management. But this has been a year long project and nothing but dissapointments so far. Hopefully I can get it turboed this summer.
I am currently designing a dyno that i will be able to sell for under $100. It will use a accelerometer to take horsepower and torque measurements. It will be similar to a g-tech but you will be able to print out torque and hp versus rpm's and maybe even air/fuel ratio's too. the only set back is you will need a laptop. I'll keep everyone updated. I might even be able to dyno some cars for free in the richmond area.
Thanks for the welcome guys!! see you on the roads
oh and my car is but ugly.......oh well, no money for looks...hehe
I am currently designing a dyno that i will be able to sell for under $100. It will use a accelerometer to take horsepower and torque measurements. It will be similar to a g-tech but you will be able to print out torque and hp versus rpm's and maybe even air/fuel ratio's too. the only set back is you will need a laptop. I'll keep everyone updated. I might even be able to dyno some cars for free in the richmond area.
Thanks for the welcome guys!! see you on the roads
oh and my car is but ugly.......oh well, no money for looks...hehe
