Project Classic Datsun: 1966 Datsun Roadster (1600) Restoration Progress
#244
Registered Member
Thread Starter
Join Date: May 2004
Location: RICHMOND, VA
Posts: 5,830
Likes: 0
Received 0 Likes
on
0 Posts
Re: Project Classic Datsun: 1966 Datsun Roadster (1600) Restoration Progress
Got some progress accomplished over the weekend!! It was nice to work on the Datsun for a change. I only had my cell phone with me so the pictures suck:
Included in the front suspension mods are:
All new Grade 8 zinc plated hardware, new energy suspension ball joint seals, bump stops, etc, new zerk fittings, new upper and lower spindle seals, new wheel bearings and wheel bearing seals, new brake lines, pads, pistons, new super comp springs, and kyb shocks (for now).
Included in the front suspension mods are:
All new Grade 8 zinc plated hardware, new energy suspension ball joint seals, bump stops, etc, new zerk fittings, new upper and lower spindle seals, new wheel bearings and wheel bearing seals, new brake lines, pads, pistons, new super comp springs, and kyb shocks (for now).
#247
Registered Member
Thread Starter
Join Date: May 2004
Location: RICHMOND, VA
Posts: 5,830
Likes: 0
Received 0 Likes
on
0 Posts
Re: Project Classic Datsun: 1966 Datsun Roadster (1600) Restoration Progress
Got some more stuff done this weekend! I got the drivers door completely finished, I got the dash back 100%, wired it up and installed it (although I may have to pull it back out to do the wipers). Started on the pass door too, it's slowly getting there!
Also a better picture of the front suspension, it's currently on hold at the moment hopfully there will be a set of Fortune Auto coilovers going on before it's finished!
Also a better picture of the front suspension, it's currently on hold at the moment hopfully there will be a set of Fortune Auto coilovers going on before it's finished!