Where can i get my flywheel resurfaced and possibly lightened around the VA Beach/Norfolk area?

 

any machine shop should have the capability to do this for you.

 

Just resurfacing or could they shave off a couple of pounds also?

 

L & W Machine (757) 857-4145 3301 Lafayette Blvd Norfolk, VA

 

Where? www.specclutch.com and order an aluminum one. You can't just take off material from the friction surface, its toleranced.

 

abacus did great on my resurface

 

^^ How much does that normally cost?

 

The material doesn't come off of the friction surface when a flywheel is lightened, it comes off of the back. Why would you think that the friction surface is lightened?

If you're going to get an aftermarket flywheel, I usually lean toward chromoly ones. I still don't trust the aluminum ones with a steel friction face, it's just too hard to pass heat from one material to another across an interface like that.. There has been a lot of improvement in that area, but only with some of the companies.
The chromoly ones are really nice usually, like the ACT or Toda parts..

 

I think it cost around $50 give or take a couple bucks. They had it done the same day I dropped it off.

 

yea like 40-45 or so i think