I want to put one in line between the S/C and the TB so I could see the temps, anyone have any idea where I can get one?
Thanks

 

www.summitracing.com Product number ATM-4372

something like that? .... picture is blurry

 

I'd like to see a digital one....cheeper. This thing only has to read intake air temps nothing crazy. Why is this so hard to find?

 

It isn't that easy of a thing to do, because the moving airflow interferes with the temp reading. You have to have a shrouded sensor, etc., and even then it's a little tricky to take a good reading I'm told.. I'm pretty sure there are a lot of stock IAT sensors you can use off of different cars though..

 

87-88 turbocoupes use them...

 

Funny you say that, I am parting out an 87 Turbo coupe right now. What part are you talking about and can it give a temp reading?

Thanks

 

LT1s use intake air temp sensors too, but i dont know how you could get a digital readout of it. i know there are plenty of industrial thermometers that you could probably port to what you need, but itd kinda hard to get an accurate readout i would think.

 

Most likely they are just a voltage output sensor, so you could probably use anything that can measure a voltage, like a digital-display voltmeter. There are ways to make it display the scale that you want too, it's probably nothing you want to mess with without a very solid electronics background though..

 

the "ACT" sensor, its on the lower intake...

How far is the car "parted"?? or does it still roll or even run??

 

Motor, trans, airbox and rear sold rest still here....need anything?