Ckboy

What motor is in the Monte Carlo?

ChevyMudtruck

350 . . couple bolt ons . .

0bd2eg

bolt ons like a 400 crank, I beam rods, flat top pistons, high ratio roller rockers, some high reving cam, bored out 750 Holley? We estimate you to have 400-500 at the flywheel man, you launch the same as I do and I only have 361whp and weigh little less than half as much.

ChevyMudtruck

Damn you only got one part of it right lol . . . its a scat 350 crank not stroked, .030 over makes it 355 c.i.,forged H beam rods, 1.6 roller rockers (1.5 be stock), cam is good to 8400. . . carb started out as a 950 but has been drilled and cut . . . oh and pistons are a +.465" dome not flat top

wish i could launch harder . . even at 3k it just blows the R6's off

0bd2eg

NEEDS MORE TIRE! I've said it from the begining, less gear then 345 35 18 rears 315 35 18 fronts. The thing should disembowel you in the corners then and break your neck off the line.

rear tires ----> http://www.tirerack.com/tires/tires....R8A6&tab=Sizes
fronts -----> http://www.tirerack.com/tires/tires....R8A6&tab=Sizes

ChevyMudtruck

Gear is pretty decent turning about 6300...... Could use a little more rpm to get off the corner and if you can find a 18 inch steel rim with 5 no5 pattern and fit 5/8s studs .... your doing better than me lol

. . . or maybe i can get ahold of a set of late model 26x10x15 slicks and put on and exhibition lol

ChevyMudtruck

Oh and you know I don't make any power...... There old technologypushrod motors and all ...

0bd2eg

Re drill some 18x12 zo6 wheels or do a custom spacer to convert,, not hard man.

ChevyMudtruck

I don't like aluminum cuz they can and probably will break.....

0bd2eg

Nah man, just cheap wheels and shit that hits walls break. Don't hit walls.