wheel spacers
#2
Re: wheel spacers
Mark, just measure it out determine where the wheel would sit using the dial calipers over there and then look and see how much thread you would have left. You know well enough to know whether or not its enough thread
#3
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: wheel spacers
10mm is about 0.4 inches. That's a lot less thread engagement than stock, and the studs aren't usually very long to begin with if the car comes with closed-end lugnuts.
#5
Registered User
Join Date: Aug 2005
Location: Hayes (Gloucester) VA
Posts: 186
Likes: 0
Received 0 Likes
on
0 Posts
Re: wheel spacers
Quick rule of thumb:go count how many full threads on a nut of the same size and pitch, that is how many you must have sticking out to engage your lugnut.
To be super technical, the shear stresses on the actual thread engagement must be greater than the failing minor diameter of the actual stud (stud should snap before engaged threads pull out or strip).
To be super technical, the shear stresses on the actual thread engagement must be greater than the failing minor diameter of the actual stud (stud should snap before engaged threads pull out or strip).
Thread
Thread Starter
Forum
Replies
Last Post
non-vtecpower
Wheels / Tires
2
02-08-2009 07:58 PM