whats the best way to put a 1 piece header on a DA teg?
 

i have a 4-1 header and cant figure out how to get on on?whats the best way to get it on?i

Re: whats the best way to put a 1 piece header on a DA teg?
 

jack the front end up as high as you can. Might help.

Re: whats the best way to put a 1 piece header on a DA teg?
 

you may have a cross member on the bottom you need to remove in order to fit in it there

Re: whats the best way to put a 1 piece header on a DA teg?
 

you might have to notch the crossmember

Re: whats the best way to put a 1 piece header on a DA teg?
 

Jack front end up and fit it in. It really shouldn't be this difficult...

Re: whats the best way to put a 1 piece header on a DA teg?
 

i have it on ramps,took the stock manifold off ,ive even took three of the motor mounts loose and jacked the motor up but it still will not fit between the block and front cross member,

Re: whats the best way to put a 1 piece header on a DA teg?
 

i can tell you from experience that you are either gonna have to purchase a new crossmember from fullrace.com( http://www.full-race.com/catalog/pro...roducts_id=113)or have it notched and reinforced by someone who does good work.

Re: whats the best way to put a 1 piece header on a DA teg?
 

crossmember had to come off my crx to get my header off...and i have a ls motor so..