Wastegate Mounting vs. Heat
09-05-2005, 05:39 PM
#1
Your Local DSM Tech
Thread Starter
Join Date: Nov 2002
Location: Newport News
Posts: 6,711
Likes: 0
Received 0 Likes
on
0 Posts
Wastegate Mounting vs. Heat
Well if some of you know the DSM HKs manifold requires a wastegate tube from the underside of the manifold to whatever location you want the wastegate to sit.
So, since I have a welder I figured I'd place the wastegate in pretty much the only location I can on my car, beside the manifold. Im just wondering if being this close will affect any seals inside the wastegate and possibly melt them. I definitly dont need to melt any seals and make my car be down any longer than it has been.
So, since I have a welder I figured I'd place the wastegate in pretty much the only location I can on my car, beside the manifold. Im just wondering if being this close will affect any seals inside the wastegate and possibly melt them. I definitly dont need to melt any seals and make my car be down any longer than it has been.
09-05-2005, 06:00 PM
#3
Your Local DSM Tech
Thread Starter
Join Date: Nov 2002
Location: Newport News
Posts: 6,711
Likes: 0
Received 0 Likes
on
0 Posts
Re: Wastegate Mounting vs. Heat
Originally Posted by 8thgengalant
i HIGHLY doubt u'll have a problem especially since sum gate flanges are actually mounted ON the manifold..u should be fine
Thread
Thread Starter
Forum
Replies
Last Post