<====3

I am new to Hondas and I am acctually looking for one, well I came accross this nice civic with a vtec swap, but the vtec is not wired up....How hard will it be to wire it up or how much would it cost for it to get wired up????? dont bash please, again im new to hondas

Flinch

You would do well to post some pertinent info; y'know, basic stuff like...oh, what year the car is, what model, what motor is in the car.

<====3

well this person was not very specific but i know it is a b16 1991 crx hf

LeetPIE

Did you just buy this car?

enot767

look at this picture



see the green plug, look to see if you have what the green plug plugs into. its the vtec solenoid as seen in the following picture

http://www.octagonwebdesign.com/b16/...CF0107_JPG.jpg

as long as you have this solenoid your in luck and the guy isnt trying to cheat you.
this is how its supposed to be wired (its really easy)

http://ef-honda.com/ben/OPSnVTECsol.jpg

STOP!! THIS IS FOR A OBD1 P72 ECU!!!! - i need to know if your car is obd0 or obd1 then i can tell you the right pinouts. however im going to list what i think you have, which is a obd1 p72 ecu.
-the solenoid has one wire coming from it which goes to A4 on your ecu
-the pressure switch has 2 wires coming from it which goes D6 on your ecu the other wire goes to any ground.

the following image shows excatly where on the ecu these are.

http://www.ff-squad.com/tech/wiring/wiring.92-95.jpg

hope that helps.

<====3

havent bought it yet, looking at a civic from a guy on this forum now,but id rather get a car that i dont have to mess with anything with wires. Im not getting this car, found out it needs much much more then that

LeetPIE

yeah id say that if vtec needs to be wired then it was a hack job and I wouldnt bother. There are people on here selling pretty good deals on already swapped cars.

B-Well

i have pre made vtec wire harnesses ready to go. pm me if you would like one. installation is included