vtec pressure switch
#1
Registered Member
Thread Starter
Join Date: Jan 2008
Location: Near Charlottesville
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
vtec pressure switch
does any1 know why my ecu is throwing a vtec pressure switch code after crossing vtec in 5th gear?(only in 5th gear) with vtec crossing at 6000rpm at about 7000rpm the car wants to tach out and sounds like its hitting the rev limit any help is appreciated.
#3
Registered Member
Join Date: Apr 2006
Location: near charlottesville
Posts: 1,051
Likes: 0
Received 0 Likes
on
0 Posts
Re: vtec pressure switch
You sure only in 5th gear? Running a stock computer or chipped one? Stock one has a speed limiter in it usually comes in 115 to 120 somewhere between them two. Could be hitting that still unsure why it would throw pressure switch code, unless oil pressure is low.
#4
Registered Member
Thread Starter
Join Date: Jan 2008
Location: Near Charlottesville
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
Re: vtec pressure switch
it used to do it whenever i crossed vtec but now it only does it in 5th, and its a stock jdm p72 and i have buried the speedometer before but now it wont let me.
#5
TurboPipingSystems
Join Date: Jul 2003
Location: USDM Land, Va Bch
Posts: 1,483
Likes: 0
Received 0 Likes
on
0 Posts
Re: vtec pressure switch
Check your oil level. If your oil level is low, you could be starving oil at high RPM's or higher speed in which the VTEC oil pressure switch is recognizing.
Higher RPM/Higher Speed= more rotating parts= more oil demand
... which also means that the connector on the sensor could be getting loose...
Higher RPM/Higher Speed= more rotating parts= more oil demand
... which also means that the connector on the sensor could be getting loose...
Thread
Thread Starter
Forum
Replies
Last Post
SHUT UP
Want to Buy / Trade ARCHIVE
14
11-27-2007 07:20 AM