tial 38mm acting funny
#1
Registered member
Thread Starter
Join Date: Jan 2004
Location: uranus
Posts: 5,063
Likes: 0
Received 0 Likes
on
0 Posts
tial 38mm acting funny
So i have a tial 38mm on my 20G setup- went from internal to external.
it came with a .8 bar spring in it and i put a 1 bar in. It acts funny in that no matter how much i tighten the boost controller it only runs 1 bar. i even tried pulling the wg line completely only to still have it run exactly 1 bar.
any idea what the prob could be?????
obivously its something to do w/ the wg so don't ask anything about having crossed vac lines.
it should boost out of control with the line pulled yet still is only 1 bar.
any help would be great.
it came with a .8 bar spring in it and i put a 1 bar in. It acts funny in that no matter how much i tighten the boost controller it only runs 1 bar. i even tried pulling the wg line completely only to still have it run exactly 1 bar.
any idea what the prob could be?????
obivously its something to do w/ the wg so don't ask anything about having crossed vac lines.
it should boost out of control with the line pulled yet still is only 1 bar.
any help would be great.
#3
Registered member
Thread Starter
Join Date: Jan 2004
Location: uranus
Posts: 5,063
Likes: 0
Received 0 Likes
on
0 Posts
Re: tial 38mm acting funny
i found the issue. i pulled off the wg and took it apart and the rubber seal is warped and leaking. I'm tryin to track 1 down so i can hopefully run the car at MIR sunday.
internal the flapper is welded shut.
internal the flapper is welded shut.
Thread
Thread Starter
Forum
Replies
Last Post