NIC668

I was reading up on it a little didnt find alot on it but I didnt look to hard. My main concern I have found is the tranny. I have a 88 crx hf. My tranny is geared for gas milage and the dx or si trannies are more for power. I am getting the motor fairly cheap but will my tranny work or do I need to look into getting something else? Also and info on this swap will be greatly apprecaited.

Thanks in adavance to anyone who can give some advice on this

95B18c1

You should pm Spoonfed and he should have alot of info on what to do and he can do the swap if needed.

NIC668

thank you.

Bert

stick to the si tranny... better gearing...also a zc tranny needs the zc intermediate shaft...there are no us replacements...you cannot use any us "counter" part...

NIC668

will the hf tranny work for a temp.? Also I can use the 87 integra tranny...should be the same as the zc tranny?

nolongerhere.

why not just wait and get a better motor?

Spoonfed

the zc motor is good motor. i hope you dont think the b16a is any better (which personally i think is a piece of shit). dont underestimate the D-series!

Bert

yes you can use the hf tranny...i'm not 100% sure on the 87 teg but i think you can use that too...

nolongerhere.

so what you're saying is there is no better honda motor than a zc?

Nato76

B16a is a piece of shit?? Are you joking?