Stupid question, perhaps some help?
#1
Stupid question, perhaps some help?
Anyways, I am learning to work on cars and want to install a cold air intake or short ram into my 92 civic hatchback. What should I do with the breathing tube/vacuum tube?
#2
Registered Member
Join Date: Jun 2005
Location: fredericksburg, va
Posts: 119
Likes: 0
Received 0 Likes
on
0 Posts
Re: Stupid question, perhaps some help?
Remove the whole stock assembly, minuses the lines that are hooked up near the top of the stock air tube. their should be 3 small rubber hoses running to your stock air box 2 of them youll plug into the nipples on your new air intake the third just cap off by sticking a small screw in the open end of the hose. Now as to which hose it is you plug off, I could only tell you if I went out to my car and looked where it ran to, and im too lazy to do that.
#3
Never Blend In
Join Date: Jul 2006
Location: Portsmouth, VA
Posts: 686
Likes: 0
Received 0 Likes
on
0 Posts
Re: Stupid question, perhaps some help?
you should get instructions with the intake kit. it will tell you where all the hoses connect, at least mine did.
#4
All Motor All Day
Join Date: Jan 2003
Location: Newport News
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
Re: Stupid question, perhaps some help?
On a 92 civic theres just 1 hose that goes from the valve cover to the intake tube. You can either:
1: Run the hose from the valve cover to the intake
or
2: Remove the hose completely and use a air breather on the valve cover.
1: Run the hose from the valve cover to the intake
or
2: Remove the hose completely and use a air breather on the valve cover.
Thread
Thread Starter
Forum
Replies
Last Post