Dillweed

Ok so my friend has a 92 civic hatch.
He has a skunk2 front upper strut tower bar that I tried to put on my 96 civic hatch.
This part should fit 92-00 civics.It fits his perfectly but won't fit mine.
Does this mean my frame is bent?

Fabrik8

Is it adjustable? Link a picture of one.

Laserjock

You have to take the mounts off from the bar. Had one on my 96 hatch that came from a del sol. If you cant figure out something this simple you need to stay out of the heat as it is frying your brain cell (singular)

Dillweed

Laserjock..I did take the mounts off.That was the first thing I did when it didn't line up right away.Stop talking shit on the internet like a little bitch.You're doing nothing to contribute possitively to this site by acting like you know everything.So go fuck yourself and run into a knife,you stupid bitch

97Ek_coupe

if you have a y7 motor the intake wont allow it to be mounted. then again the holes probably arent lining up to the strut tower.

Fabrik8

So if it won't fit, at least one of these two things is true:

1. It doesn't fit a 96
2. Your frame is bent

You could try another brace and see if it fits..

Laserjock

1. Remove the 4 - 14mm nuts from the shock tower.

2. Remove 1 or both of the Allen head thru bolts from the strut bar.

3. Install the 2 end plates. Do not tighten the 14mm nuts until last.

4. Slide the bar into the endplates.

5. Install the Allen head screws.

6. Tighten the 14mm nuts.

7. Have a cool drink of lemonade or iced tea to cool off your hot head



Note: If it still doesnt fit, you can:

slot the holes in the end plates

run and cry to your momma

pay $80/hour for someone to install it for you

give up installing bolt ons completely

...

Dillweed

Thank you Fabrik8