pickupguy89

Ok so this is my first time doing this, im about to pick up a s14 and hes got some of the stuff to do it but still needs some stuff to finish it. this is what it comes with.

1) Comes with clutch pedal/master cylinder already installed.
2) Manual 5-speed trans with shifter/clutch fork included. (used)
3) Clutch disc + pressure plate + all necessary bolts included. (used)
4) Drive shaft included. (used)

What all will i need to finish it and how much is it?

where should i get these parts from...etc

thanks would like to know this ASAP

RE-SPECGARAGE

Doesnt look like you need anything else

pickupguy89

he told me i would need, trans plate/gasket
clutch lines
slave cylinder
speed sensor
clutch kit (since his is used)

and what about lower shift boot, boot ring, shift dust cover?

RE-SPECGARAGE

Why are you asking if you know what you need?

Thats all minor stuff you can pick up at advanced auto. The speed sensor is the same auto/5speed.

blksylv

i thought the auto speed sensor was bigger than the manual one and wouldnt fit iirc?

ryanherington

do you have to run a 5 speed ecu on 240s?

blksylv

as far as s14 if you run an auto ecu on a manual car itll throw codes for the missing auto components iirc

pickupguy89

and im just making sure im not missing anything.

blksylv

http://www.ka24development.com/transmission_swap.html

this site is a good source for any other info that you should need concerning the swap