streEtFyter

Does anyone know of a reputable shop that can roll quarter panels in the 757 area? I have an EP3 that is lowered with Skunk2 coilovers. It tucks pretty hard in the rear like i want it to but I want to get a rear camber kit to straighten the wheels up a bit while keeping the rear tucked.

audiophile24

i used a bat some duct tape and a pair of channel locks worked fine for me looked good too

streEtFyter

did you appply heat? did the paint chip?

audiophile24

no heat...just gotta have the right angle from the bat on the tire and the paint will not crack on the outside just inside then i spray bombed the inner fender black again my hatch tucked 17s

streEtFyter

thanx man.